Installation Guide

12
A Access Panel to Electrical Supply Connection
B Power Cord Opening
C Recessed Area
A UL Listed Strain Relief
B Power Cord
C Jumper Wire
Step 3: Make Electrical Connection

POWER CORD - U.S.A. ONLY
Electrical Shock Hazard
Disconnect power before servicing.

Do not use an extension cord.

WARNING
3 Wire connection: power supply cord
IMPORTANT: Use this method only if local codes permit connecting chassis ground conductor to neutral wire of power
supply cord.
1. Disconnect power.
2. Remove the access panel located on the bottom right-hand side of the back panel to uncover the electrical terminal
block
3. Install a UL listed strain relief (not provided) to the power cord opening in the bracket, and then completely tighten the
strain relief nut.
4. Thread the end of the power cord through the strain relief.
NOTE: Allow enough slack to connect the wires to the terminal block.