Installation Guide
16
Step 3: Make Electrical Connection (continued)
Connect to the House Electrical Supply
IMPORTANT: Use the 3-wire cable from home power supply where local codes permit a 3-wire connection.
1. Disconnect power.
Grounded Neutral
A Junction box
B Black Wires
C Neutral (White) Wire
D Ground (Green or Bare) Wire
E Cable from Range
F UL Listed Conduit Connector
G Red Wires
H UL Listed Wire Connectors
I House Electrical Supply
2. Connect the 2 black wires together using a UL listed wire connector.
3. Connect the neutral (white) wire and the ground (green or bare) wire (of the range cable) using a UL listed wire
connector.
4. Connect the 2 red wires together using a UL listed wire connector.
5. Install junction box cover.
Connect To The Range
IMPORTANT: Use this method only if local codes permit connecting chassis ground conductor to neutral wire of power
supply cord.
1.
NOTE: Allow enough slack to easily attach the wires to the terminal block.
2. Remove the access panel located on the bottom right-hand side of the back panel to uncover the electrical terminal
block.
A Electrical Access Panel
B Conduit Opening
C Recessed Area