Installation Guide

Step 3: Make Electrical Connection (continued)

Connect to the Range

IMPORTANT: Use this method for new branch-circuit installations (1996 NEC), mobile homes, recreational vehicles, or

in an area where local codes prohibit grounding through neutral.

1. 

NOTE: Allow enough slack to easily attach the wires to the terminal block.

2. Remove the access panel located on the bottom right-hand side of the back panel to expose the electrical terminal

block.

A Electrical Access Panel

B Conduit Opening

C Recessed Area

3. 

relief nut.

4. 

block.

A Ground Screw

B Terminal Block

C Jumper Wire

D Electrical Cable Wires

E UL Listed Strain Relief

5. 

conduit and tighten ground screw.

6. Loop the green jumper wire removed from the ground screw back onto its end that is fastened to the center post on

the terminal block.

7. Use a 5/16” nut driver to connect the neutral (white) wire to the center terminal block post with one of the 10-32 hex

nuts.