Installation Guide

Attachment to oor or rear wall
Bracket
The screw must
enter to wood or
concrete
Wall sill plate
The screw must enter to wood
Adjacent cabinet
or nal location of
range side panel
Lo c A Lo c B
L
Rear Wall
oc C
Two screws must
enter oor or wall
at Loc A,B, or C.
Plug into
Step 2: Imstall Anti-Tip Bracket (continued)
2: Secure The Bracket
The bracket must be screwed to either the FLOOR or REAR WALL.
FLOOR Installation:
• Wood oor: Use the screws provided to secure the bracket using the pair of marked holes (either Loc A or B).
• Concrete oor: Using a concrete bit, drill a 5/32” pilot hole 2” deep into the concrete at the center of each of the
marked holes (either Loc A or B). Use the screws provided to secure the bracket into the oor.
REAR WALL Installation:
Use the 2 screws provided to secure the bracket using the pair of marked holes at Loc C. The screws MUST enter a
wood sill plate. If the wall contains any metal studs or similar materials, then the oor must be used.
3: Check The Bracket
After installing the bracket, slide the range into its nal location. The rear leveling leg must be fully inserted into the AN-
TI-TIP bracket as shown in Step 1. To check if the bracket is installed and engaged properly, look underneath the range
to see that the rear leveling leg is engaged in the bracket. On some models, the storage drawer or kick panel can be
removed for easier inspection. If visual inspection is not possible, slide the range forward, conrm the anti-tip bracket is
securely attached to the oor or wall, and slide the range back so the leveling leg is under the anti-tip bracket. If the range
is pulled from the wall for any reason, always repeat this procedure to verify the range is properly secured by the anti-tip
bracket.
NOTE: The anti-tip bracket must be PROPERLY INSTALLED, and the rear leveling leg must be FULLY ENGAGED into
the bracket to prevent the range from tipping. NEVER remove the leveling legs. This will prevent the range from being
secured to the ANTI-TIP bracket properly.
Step 3: Make Electrical Connection
• This range is equipped with a CSA International Certied Power Cord intended to be plugged into a standard 4-wire
receptacle (NEMA type 14-50R) wall receptacle. Be sure the wall receptacle is within reach of range’s nal location.
10