Installation Guide

WARNING
Electrical Shock Hazard
Disconnect power before servicing. Plug into a grounded outlet.
Do not use an extension cord.
Failure to do so can result in death, re, or electrical shock.
Step 3: Make Electrical Connection (continued)
To convert this appliance to 3 prong plug or direct junction box connection, contact a certied electrician for installation.
Step 4: Install Range
IMPORTANT: If the range is moved to adjust the leveling legs, make sure when you move the
range back into its nal location that the anti-tip bracket is
engaged by repeating steps 1 through 9.
1. Slide range into nal location, making sure rear leveling
leg slides into anti- tip bracket.
Leave a 1” (2.e cm) gap between the back of the range
and the back wall.
2. Place the outside of your foot against the bottom front to
keep the range from moving,
and then grasp the back of the range, as shown.
3. Slowly attempt to tilt the range forward. If you encounter
immediate resistance, the range
foot is engaged in the anti-tip bracket. Go to Step 8.
4. If the rear of the range lifts more than 1/2” (l.3 cm) o󰀨 the
oor without resistance, stop tilting the range and lower it
gently back to the oor. The range foot is not engaged in
the anti-tip bracket
IMPORTANT: If there is a snapping or popping sound when lifting the range, the range
may not be fully engaged in the bracket. Check to see if there are obstructions keeping
the range from sliding to the wall or keeping the range foot from sliding into the bracket.
Verify that the bracket is held securely in place by the mounting screws.
5. Slide the range forward and verify that the anti-tip bracket is securely attached to the oor or wall.
6. Slide range back so the rear range foot is inserted into the slot of the anti-tip bracket.
7. Repeat steps 1 through 3 to ensure that the range foot is engaged in the anti-tip bracket.\If the rear of the range lifts more than
1/2” (l.3 cm) o󰀨 the oor without resistance, the anti-tip bracket may not be installed correctly. Do not operate the range without
anti-tip bracket installed and engaged.
8. Move the range into its nal location. Check that the range is level by placing a level on the oven bottom.
NOTE: The range must be level for optimum cooking and baking performance.
9. If needed, use a wrench to adjust the height of the leveling legs until the range is level from side to side and front to back.
11