Installation Guide

WARNING
Electrical Weight Hazard
Use two or more people to move and install the range. Failure to do so can result in back or other injury.
Step 1: Unpack Range
1. Remove shipping materials, tape, and lm from the range. Keep cardboard bottom under range. Do not dispose of
anything until the installation is complete.
2. Remove oven racks and parts package from oven and shipping materials.
3.To remove cardboard bottom, rst take four cardboard corners from the carton. Stack one cardboard corner on top
of another. Repeat with the other two corners. Place them lengthwise on the oor behind the range to support the
range when it is laid on its back.
4. Using two or more people, rmly grasp the range and gently lay it on its back on the cardboard corners.
5. Remove cardboard bottom.
NOTES:
• The leveling legs can be adjusted while the range is on its back.
• To place range back up into a standing position, put a sheet of cardboard or hardboard on the oor in
front of range to protect the ooring. Using two or more people, stand range back up onto the cardboard
or hardboard.
Step 2: Imstall Anti-Tip Bracket
NOTE: An anti-tip bracket kit is provided with the range.
WARNING: Tip Over Hazard
• A child or adult can tip the range and be killed.
• Connect anti-tip bracket to rear range foot.
• Reconnect the anti-tip bracket if the range is moved.
• Failure to follow these instructions can result in death or serious burns to children and adults.
IMPORTANT: DO NOT completely remove the rear leveling leg. The anti-tip bracket uses either the right-hand or left
hand, rear leveling leg to secure the range to the oor.
1: Locate The Bracket
Determine the nal location of the range before attempting to install the bracket.
A. Place the bracket on the oor with the back edge against the rear wall. If the range does not reach the rear wall, align
the back edge of the bracket with the rear panel of the range in its nal location. NOTE:
If bracket does not touch the rear wall, you MUST screw bracket to FLOOR .
B. Position the side of the bracket against either the left or right cabinet. If there is no adjacent cabinet, align the edge
of the bracket with the side panel of the range in its nal location. If the countertop overhangs the cabinet, o󰀨set the
bracket from the cabinet by the amount of overhang.
C. Mark the location for the pair of holes to be used (see illustration below).
NOTE: For FLOOR installation use either Loc A or B. For REAR WALL installation use Loc C.
9