User manual

Warning! Do not use standard bulbs!
These develop too much heat and may
damage the machine!
Before replacing the bulb, disconnect
the mains plug; with a permanent con-
nection: fully unscrew or deactivate the
fuse.
1. Unscrew cover above the bulb (this can
be found directly behind the loading aper-
ture, at the top; refer to “Description of
machine” section.)
2. Replace defective bulb.
3. Screw cover back down.
Check the correct positioning of o-ring gas-
ket before screwing back the door light cov-
er. Do not operate the dryer when missing o-
ring gasket on door light cover.
Warning! For safety reasons, the cover
must be screwed down tightly. If this is
not done, the dryer must not be
operated.
Machine settings
Setting Implementation
Buzzer permanent
on/off
1. Turn the programme selector to any programme.
2. Press simultaneously the Delicate (Schon) and Sensitive buttons and hold
down for approx. 5 seconds.
3. The buzzer is by default always off. You can use the buzzer option to
activate or deactivate sound but the machine does not memorize your
selection.
Water hardness
1)
1. Turn the programme selector to any programme.
2. Press simultaneously the Delicate (Schon) and Time (Zeitwahl) buttons
and hold down for approx. 5 seconds. The current setting is on the dis-
play:
–
low conductivity <300 μS/cm
–
medium conductivity 300-600 μS/cm
–
high conductivity >600 μS/cm
3. Press the Start / Pause button sequentially until you set desired level.
4. To memorize setting press simultaneously the Delicate (Schon) and Time
(Zeitwahl) buttons or turn knob to Off (Aus) position
Emptying water res-
ervoir
- warning
off
2)
1. Turn the programme selector to any programme.
2. Press simultaneously the Sensitive and Time (Zeitwahl) buttons and hold
down for approx. 5 seconds.
The current setting is on the display:
–
warning
icon and - warning message is off
–
warning
icon and - warning message is switched on
1) Water contains, a variable quantity of limestone and mineral salts of which quantities vary according
to geographical locations thus varying its conductivity values. Relevant variations of the conductivity
of the water compared to those prefixed by the factory could slightly influence the residual humidity
of the laundry at the end of the cycle. Your dryer allows you to regulate the sensitivity of the drying
sensor based on conductivity values of the water.
2) By default the warning LED is always on at the end of the drying cycle or during the cycle if the water
reservoir is full. When using an external drain for the condensed water warning can be offi
Technical data
Parameter Value
Height x width x depth 85 x 60 x 58 cm
Drum volume 108 l
Depth with loading door open 109 cm
78