User manual

Problem
1)
Possible cause Remedy
Unsatisfactory
drying result.
Incorrect programme selection. Do the selection of the applicable
programme.
2)
The filter is clogged.
Clean the filter.
3)
The Dry Plus (Trocken+) option was
in minimum level.
4)
Change the Dry Plus (Trocken+) op-
tion to the moderate or maximum
level.
4)
Too high volume of the load. Obey the maximum load volume.
The airflow grill is clogged. Clean the airflow grill in the bottom
of the appliance.
Dirt on the humidity sensor in the
drum.
Clean the front surface of the drum.
Incorrect remaining laundry moisture
degree.
Adjust remaining laundry moisture
degree.
5)
The heat exchanger is clogged.
Clean the heat exchanger.
3)
The loading
door does not
closed
The filter not locked in the position. Put the filter in the correct position.
The laundry is locked between the
door and the seal.
Put the load correctly in the drum.
Err (Error) on
the display.
You try to change the programme
or the option after the start of the
cycle.
Turn the tumble dryer off and on.
Make the new selection.
The option you try to activate is not
applicable with the selected pro-
gramme.
Turn the tumble dryer off and on.
Make the new selection.
No drum light
Defective drum lamp. Contact the service centre to re-
place the drum lamp.
Abnormally
elapsing time
on the display.
The time to end is calculated on the
basis of the volume and dampness
of the laundry.
The automatic procedure — this is
not the appliance malfunction.
Programme in-
active.
The water container is full. Drain the water container, push the
Start/Pause button.
3)
19