User manual

Problem
1)
Possible cause Remedy
The laundry not spun sufficiently. Spin correctly the laundry.
Very high room temperature - this is not
the appliance malfunction.
If possible, lower the room temperature.
1) If there is an error message on the display (e.g. E51): Turn the tumble dryer off and on. Make a selection of the
new programme. Push the Start/Pause button. Does not operate? - contact the service centre and give the error
code.
2) follow the programme description — see PROGRAMMES chapter
3) see CARE AND CLEANING chapter
4) see section WATER HARDNESS in HINTS AND TIPS chapter
5) Note: After maximum 5 hours the drying cycle ends automatically (see Drying cycle complete section).
Drum internal lamp
This appliance has an internal lamp that
comes on when you open the door and
goes off when the door is closed.
Warning! Do not look directly into the
beam of the lamp.
Important! To replace the internal lamp,
contact the service centre.
Disconnect the mains plug from the mains
socket before the replacement of the inter-
nal lamp.
Technical information
height x width x depth 850 x 600 x 600 mm (maximal 640 mm)
drum volume 118 l
maximum depth with the load door opened 1090 mm
maximum width with the load door opened 950 mm
adjustable height 850 mm (+ 15 mm - feet regulation)
the appliance weight 56 kg
maximum load volume
8 kg
voltage 230 V
frequency 50 Hz
necessary fuse 4 A
total power 800 W
energy efficiency class A
energy consumption kWh/cycle
1)
1,92 kWh
annual energy consumption 108,3 kWh
type of use Domestic
permitted ambient temperature + 5°C to + 35°C
1) 8 kg of cotton, centrifuged at 1000 rpm with reference to EN 61121
Installation
Appliance positioning
• The tumble dryer must be installed in a
clean position, where dirt does not col-
lect.
• Air must flow freely around the appliance.
Make sure that the front airflow slots in
the bottom of the appliance are not
blocked .
43