Installation Sheet

INSTALLATION INSTRUCTIONS

For Model 5748-03

READ AND SAVE THESE INSTRUCTIONS

These instructions are provided for your safety. It is essential to read them carefully and completely before installing the

light fixture. We strongly suggest that all direct-wired fixtures be installed by a qualified, licensed electrician.

NCTEUR

PREPARING FOR INSTALLATIONS

Remove all contents from the carton. See the important notes above. Shut off the power at the circuit breaker and completely remove

the old fixture from the ceiling, including the old mounting strap.

The mounting plate(A) contains several pairs of threaded holes. Find holes that match the spacing of the holes on the junction box. Pull

the house wires through the center of the mounting plate(A). Place the mounting plate(A) over the junction box to alignwith the holes

on the fixture’s backplate(D). Secure the mounting plate(A) to the junction box by securely tightening the mounting screws(B).

CONNECTING THE WIRES

Attach the fixture’s wire to the power supply wires at the junction box. Connect the black wire to the black wire(or smooth), the white

wire to the white(or ribbed),the ground wire to the ground wire(green or copper). Twist the end of the wire pairs together, and

twist on a wire connector. Make sure all twists are in the same direction. If there is no ground wire(green or copper) from the junction

box, locate the ground screw(C) on the mounting plate(A) and wrap the fixture’s ground wire around the green ground screw(C). Use a

screwdriver to secure the ground screw(C) onto the mounting bracket. Tuck all wires neatly into the junction box.

FINISHING THE INSTALLATIONS

Place the fixture’s backplate(D) against the mounting surface and fasten the backplatescrews(E).Secure the glass(G) and the metal

washer(H)onto the socket by screwing the socket ring(I) until it is tightened. Adjust the glass to level. Install light bulb(s)(not included) in

accordance with the fixture’s specifications. Do not exceed the recommended maximum wattage.

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER

BEFORE INSTALLATION

AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.

PAGE 1
INSTALLATION INSTRUCTIONS For Model 5748-03 READ AND SAVE THESE INSTRUCTIONS These instructions are provided for your safety. It is essential to read them carefully and completely before installing the light fixture. We strongly suggest that all direct-wired fixtures be installed by a qualified, licensed electrician. WAR NI NG ! S H UT PO W ER O F FNCTEUR AT F U S E O R CI RC UIT B R E AK E R BE FO R E I N STAL L AT I O N AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.