Data Sheet

www.veear.eu
18 EasyVR 3 (Plus) User Manual (1.0.17)
EasyVR 3 as a Development Board
The EasyVR 3 module has been designed to allow use as a
standalone development board when combined with a USB-
Serial adapter.
The QuickUSB adapter cable can be used to program voice
commands and sound outputs directly to an EasyVR 3 module
and quickly test its functions from your PC.
Just connect the microphone and an 8Ω speaker to the
module, plug-in the adapter cable and you are ready to go.
The EasyVR 3 boot mode is managed automatically through
the serial handshake lines and you don’t need to set any
jumper.
Getting started
1. Connect the microphone to the 2-way socket MIC (J6)
2. Connect an 8Ω speaker to the 3-way socket SPEAKER (J5)
3. Connect a QuickUSB cable to the 3x2 pins socket (J7)
4. Plug the USB end of the adapter cable to your PC.
The first time it may take some time to install the required drivers (see Software Setup)
5. If your installation is successful you will see a new virtual COM port in your Device Manager:
(The actual COM port number may vary)
6. Now start the EasyVR Commander software
7. Choose your COM Port and click connect
8. Then enjoy your EasyVR!