Data Sheet

www.veear.eu
User Manual (1.0.17) EasyVR 3 (Plus) 25
Prepare the software
1. Install the EasyVR Commander, available on the VeeaR website:
http://www.veear.eu/downloads/
2. Install a recent version of the Arduino IDE, available from the official Arduino community:
https://www.arduino.cc/en/main/software
3. Install the EasyVR Arduino libraries
5
on your PC.
You can use the “Library Manager” in recent versions of the Arduino IDE to automatically
download and install the latest version of the library.
In alternative, to perform a manual install see:
https://www.arduino.cc/en/Guide/Libraries
Figure 1 - Manual installation of Arduino library
Prepare the hardware
1. Insert the EasyVR Shield on top of your Arduino board
2. If you want audio output, either wire an 8Ω speaker into the SPEAKER connector (J5) on the
EasyVR module or connect headphones or amplified speakers to the LINE OUT 3.5mm audio jack on
the Shield
3. Connect the supplied microphone to the MIC connector (J6) on the EasyVR module
4. Make sure the Mode Jumper (J7) is in the correct position (see table below)
5. Connect a USB cable from your PC to the appropriate USB port for your Arduino board (see table
below)
5
The Arduino library archive file can also be found in the EasyVR Commander program folder.