User Manual

USING THE REMOTE CONTROL
The remote starter is equipped with a 1-way 5-button multi-channel remote control.
LOCK
0.5 SEC.
Locks all doors, arm the anti-
theft system and activates
the Alarm (if installed). Press
LOCK for 4 seconds to acti-
vate the Panic Mode
STOP
0.5 SEC.
Remote-Stop.
START
3 SEC.
Remote-start the vehicle.
Press START again to reset
the runtime. (See: remote-
starter features, page
6)
TRUNK
3 SEC.
Opens the trunk, and deacti-
vates the Alarm (if installed).
The Alarm ignores the trunk
zone until it is closed.
UNLOCK
0.5 SEC.
Unlocks all doors, disarms the
anti-theft system and deacti-
vates the Alarm (if installed).
Press and release
TRUNK and than
press UNLOCK
AUXILIARY1
0.5 SEC.
AUXILIARY1 (See:Auxiliary
use, page 9)
Press and release
TRUNK and than
press LOCK
AUXILIARY2
0.5 SEC.
AUXILIARY2 (See:Auxiliary
use, page 9)
The remote flash DEL BLUE when a button is pressed.
The remote flash DEL GREEN when the remote is transmitting the informations. For car command confirma-
tion see: ALARM ACTIVITY, page 11
WARNING
Do not start the vehicle indoors (garage, underground parking).
Do not remote-start the vehicle with a passenger inside.
When servicing the vehicle enable VALET MODE (See page 7).
NOTE
The system can be configured in three different ways: Remote Start only, alarm only or alarm and remote
starter.
The options vary by vehicle, the components can be added to the system and the functions on the vehicle.
INDUSTRY CANADA USER NOTICE
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the
device.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the
equivalent isotropically radiated power (EIRP) is not more than that required for successful communication.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to
this equipment. Such modifications could void the user’s authority to operate the equipment.
GOVERNMENT REGULATIONS
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
Page 3 / 12