User Manual

interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio com-
munications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with the Industry Canada Radio Standards Specification RSS 210. Its use is authorized only
on a no-interference, no-protection basis; in other words, this device must not be used if it is determined that it
causes harmful interferences to services authorized by IC. In addition, the user of this device must accept any radio
interface that may be received, even if this interference could affect the operation of the device.
Warning! Changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate this device.
REMOTE-STARTING
REMOTE-STARTING THE VEHICLE
This Remote-Starter supports both manual and automatic transmission vehicles. For manual transmission vehicles
see the Ready Mode section.
REMOTE-STARTING
STEP1
To remote-start the vehicle press the START button for approximately 3 sec-
ond.
STEP 2
The parking lights will turn on to indicate a response to the Remote-Start sig-
nal.
STEP 3
Approximately 5 seconds later the engine will crank. Once the vehicle starts the
parking lights will turn on and remain on for the entire duration of the Remote-
Starter runtime, or until the Remote-Starter is shut down.
If the vehicle fails to start on the first attempt, the Remote-Starter will wait 3 seconds before it will attempt
to start the vehicle again. The Remote-Starter will attempt to start the vehicle 2 times (default) before
giving up. (See Failed Remote Start page 12)
ACCESSORY PRESET
Heater & Heated Seat(s): When leaving the vehicle it is recommended that the driver pre-set the climate controls
in preparation for a later Remote-Start. When the vehicle Remote-Starts, the current (or last) setting for the climate
controls, windshield wipers (and other accessories) will be used. When setting the blower motor (fan speed) and
heated seats (if equipped) should not be left on HIGH. It is recommended to leave these settings on either a LOW
or MEDIUM setting.
Windshield Wipers & Radio & Headlights: Some vehicles require the radio, windshield wiper, headlight circuits
to become energized while running under Remote-Start. When leaving the vehicle you must ensure that the wind-
shield wiper and headlight switches are turned off. Leaving the headlights on with some vehicles could cause them
to remain on even after the Remote-Starter has shut down, resulting in a dead battery.
Rear Defrost: On most vehicles the Rear Defrost can only be activated after the vehicle has been started and in
most cases this feature is not included with a Remote-Starter installation. On some vehicles it may be possible for
the installer to hook this feature up so it either automatically enables after Remote-Start or can be enabled by using
an AUX output.
Driver Presets: Some vehicles retain different seat, mirror and radio settings for each driver. Different driver
presets are not controlled by the Remote-Starter, however they may be controlled with the Bypass/Interface Kit.
READY MODE (MANUAL TRANSMISSION ONLY)
Page 4 / 12