Owner's Manual
Table Of Contents
By
default the Alarm will not send
an
audible confirmation (horn/siren) after the first signal
has
been
received from the remote transmitter(s).
SILENT:
Press the
LOCK
or UNLOCK button
ONCE
and the park lights will flash, but the
horn/siren will
NOT
confirm the signal.
AUDIBLE:
Pressing the same button TWICE consecutively (LOCK or UNLOCK) the park
lights will flash, and the horn/siren will confirm the signal.
The Alarm can
be
programmed to audibly confirm the signal
on
the first button press. (See Installation
Guide).
The following characteristics enhance your vehicle's security :
If
the Alarm system is active and the horn/siren is sounding :
• Press the UNLOCK button
ONCE
to stop the alarm sound. The Alarm will remain active and will
immediately resound
if
a zone is (re)triggered.
• Press the UNLOCK button TWICE to stop the alarm sound, deactivate the Alarm, and unlock
the doors.
• When the vehicle is unlocked the horn/siren will sound with several short chirps to indicate the
zone
that
has previously triggered the Alarm. (See Remote-Start/Alarm Diagnostics page 1 0)
NOTE
1:
If
the
vehicle
is
running
with
the
Remote-Starter
and
the
Alarm
is
triggered
the
Remote-Starter
will
shut
down
immediately.
This
applies
to
Cold
Start.
Turbo
and
Idle
Modes.
However
the
vehicle
can
be
Remote-
Started
at
a
later
time
(i.e.
The
Alarm
will
not
cancel
Cold
Start
Timer>.
NOTE
2:
When
an
alarm
infraction
has
occurred
the
LED
on
the
antenna
will
quickly
flash
3
times
followed
of
a
long
pause.
It
will
continue
to
flash
until
the
alarm
is
disabled.
When the
LOCK
button is pressed to ARM the Alarm (non Valet Mode),
it
will indicate
if
there are
any zones which are currently active. The Alarm will sound with several short chirps to indicate which
zone is active. A silent ARM or only 1 chirp indicates
that
no
zones are currently active. (See Remote-
Starter/Alarm Diagnostics page
10)
This option will disable any zone
that
triggers the alarm 3 consecutive times. The zone will automati-
cally re-enable once the
LOCK
button or the UN
LOCK
button is pressed.
The Alarm system supports FSS2Z (2
stage-
3 wire) Shock Sensors. The Shock Sensor will produce a
short audible warning
on
a weak shock, and will trigger a
full
alarm
on
a strong shock. Whenever the
vehicle
is running with the Remote-Starter the shock sensor is ignored until the Remote-Starter shuts
down. However the Alarm can
be
set to monitor the Shock Sensor
if
the vehicle is Armed
AFTER
the
vehicle is Remote-Started.
To
locate your vehicle in a busy parking lot press the
LOCK
button for 3 seconds to sound the horn/siren
(If
installed) and flash the parking lights. Press unlock to cancel
this
Mode.
Note:
If
an
Alarm
pre-triggered
zone
is in
memory.
this
Mode
will
NOT
clear
this
zone
from
memory.
Several factors may affect the operating range of the remote transmitter:
• A weak transmitter battery.
• The operating environment such
as
in the
city
and airports due to radio interference, cell phone
towers, etc ...
Page 9 I
10