Owner's Manual

This Remote-Starter supports both manual and automatic transmiss
on
vehicles.
For
manual transmis-
sion vehicles
see
the Ready Mode section.
REMOTE-STARTING
STEP
1
STEP
2
STEP
3
......
..
.................
..
.
................
...
..
·.··
To
remote-start the vehicle press the
START
button.
The parking
lights will
turn
on
to indicate a response to the Remote-Start
signal.
Approximately 5 seconds later the engine will crank.
Once
the vehicle
starts the parking lights
will
turn
on
and remain
on
for the entire duration
of the Remote-Starter runtime, or
until
the Remote-Starter
is
shut down.
Heater
&
Heated
Seat(s):
When
leaving
the vehicle
it
is
recommended
that
the driver pre-set
the climate controls in preparation for a later Remote-Start. When the vehicle Remote-
Starts, the current (or last) setting for the climate controls, windshield wipers (and other
accessories) will
be
used. When setting the blower motor (fan speed) and heated seats
(if
equipped) should not
be
left
on
HIGH.
It
is
recommended to leave these settings
on
either
a
LOW
or
MEDIUM setting.
···••
•
••••••·•·•·•.•••·•</)
3
n••<
Windshield
Wipers
&
Radio
&
Headlights:
Some vehicles require the radio, windshield wiper,
headlight circuits to become energized
while running under Remote-Start. When leaving
/
j!LL
~~~!i
illi
the vehicle
you
must ensure
that
the windshield wiper and headlight switches are turned
off. Leaving the headlights
on
with some vehicles could cause them to remain
on
even
after the Remote-Starter has shut down, resulting in a dead battery.
Rear
Defrost:
On
most vehicles the
Re
.ar Defrost can only
be
activated after the vehicle
has
been started and in most cases this feature
is
not included with a Remote-Starter installa-
tion.
On
some vehicles
it
may
be
possible for the installer to hook this feature up
so
it
ei-
ther automatically
enables after Remote-Start or can
be
enabled
by
using
an
AUX output.
·····
·
••·
·
·•••••
··
••
·
••>ii
•i
······•·•··
Driver
Presets:
Some vehicles retain different seat, mirror and radio settings for each
•••i•••• ·
••
••
•••••••·•·
i••••••••••••••
>
driver. Different driver presets are not controlled
by
the Remote-Starter, however they may
be
controlled
with the Bypass/Interface Kit.
Page 3
I
10