User's Manual

Table Of Contents

Please review the following cautions and warnings.

Environmental and mounting specications

Operating temperature: 0 - 40°C (32 - 104°F)

Storage temperature: -40 - 70°C (-40 - 158°F)

Humidity: 0 to 90% non-condensing

Operating Altitude: <2250m (7400ft)

Elevated Operating Ambient: If installed in a closed or multi-unit rack assembly, the operating

ambient temperature of the rack environment may be greater than room ambient. Therefore,

consideration should be given to installing the equipment in an environment compatible with the

maximum ambient temperature (T

) speciﬁed by the manufacturer.

Circuit Overloading: Consideration should be given to the connection of the equipment to the

supply circuit and the effect that overloading of the circuits might have on overcurrent protection

and supply wiring. Appropriate consideration of equipment nameplate ratings should be used

when addressing this concern.

This product is intended to be supplied by a Listed Direct Plug-In Power Unit marked LPS or

Class 2 and rated 5V DC, 1A.

Federal Communication Commission (FCC) – USA

This device complies with Part 15 of FCC Rules. Operation is subject to the following two

conditions: (1) this device may not cause harmful interference, and (2) this device must accept

any interference received; including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in residential installation. This equipment generates, uses, and

can radiate radio frequency energy, and if it is not installed and used in accordance with the

instruction manual, it may cause harmful interference to radio communications. However, there

is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Page 9

Cautions and Warnings