Installation Manual

“Contains IC: 7280B-111T15C “
The FCC ID/IC ID can be used only when all FCC/IC compliance requirements are met.
Antenna Installation
Only the same or equivalent-type as shown below may be used with this module.
Other un-equivalent types of antennas may require additional authorization for
operation. The equivalent type means the same type that results in similar in-band
and out-of-band radiation patterns.
Antenna type
2.4GHz band Peak Gain (dBi)
PIFA 0.74
Manual Information to the End User
The end user manual shall include all required regulatory notices as show in the
following section.
Federal Communication Commission regulatory notice:
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressly approved by the party responsible for