User's Manual

Cabling

The unit requires 48V DC power, which is delivered by the PoE injector, through the

surge protector, over a straight-through Ethernet cable.

To install the weatherproof connector

1. Unscrew the coupling ring from the waterproof connector, remove the sealing gland,

and thread the RJ-45 plug through the connector components.

2. Insert the RJ-45 plug into the PoE port on the unit and install the weatherproof panel

connector onto the threaded coupling at the port.

3. Slide the sealing gland along the cable into panel connector.

4. Thread the coupling ring onto the panel connector and tighten it until the sealing

gland is compressed, making a watertight seal on the cable.

Coupling RingSealing Gland

Waterproof Panel

Connector

FortiAP-222C-QuickStart.indd 9 2014-08-05 3:33:18 PM