User's Manual

11
To Connect the FortiAP unit
1. Connect grounding cables to the grounding lugs on both FortiAP unit (bottom
middle of unit) and the PoE injector, then connect the other ends of the cables to
appropriate ground connections.
2. Connect the surge protector’s grounding cable to an appropriate ground connection.
3. Connect the region-specific AC plug adapter to the AC power adapter by inserting
the round disk into the adapter and rotating clockwise until you hear the disk lock in
place.
4. Insert the DC plug of the power adapter into the DC IN port on the PoE injector, then
plug the AC adapter into an appropriate power outlet. The PWR LED will light up.
5. Connect one end of a cross-over Ethernet cable to the Network port on the PoE
injector. Connect the other end to the FortiGate controller or an Internet connection.
6. Using the supplied weatherproof connector, connect the weatherproof,
straight-through Ethernet cable on the right side of the surge protector to the PoE
port on the bottom of the FortiAP unit, as described in “Cabling” on page 9.
7. Connect the straight-through Ethernet cable on the left side of the surge protector
into the AP/Bridge port on the PoE injector.
Controller or Internet
PoE Injector
Power
Adapter
Surge
Protector
Internet
Weatherproof
Connector
FortiAP-222C-QuickStart.indd 11 2014-08-05 3:33:19 PM