User Manual

- 111 -
Syntax
show ipv6 mld snooping querier
Default Setting
None
Command Mode
Privileged Exec
User Exec
Display Message
MLD Snooping Querier Mode: Specify the Snooping Querier Address to be used as source
address in periodic MLD queries. This address is used when no address is configured on the VLAN
on which query is being sent.
Querier Address: Specify the Snooping Querier Address to be used as source address in periodic
MLD queries. This address is used when no address is configured on the VLAN on which query is
being sent.
MLD Version: Specify the MLD protocol version used in periodic MLD queries.
Querier Query Interval: Specify the time interval in seconds between periodic queries sent by the
snooping querier. The Query Interval must be a value in the range of 1 and 1800. The default value
is 60.
Querier Expiry Interval: Specify the time interval in seconds after which the last querier information
is removed. The Querier Expiry Interval must be a value in the range of 60 and 300. The default
value is 60.
7.2.9.2 show ipv6 mld snooping querier vlan
This command display MLD snooping querier vlan information on the system.
Syntax
show ipv6 mld snooping querier vlan <1-3965>
Default Setting
None
Command Mode
Privileged Exec
User Exec
Display Message
MLD Snooping Querier Vlan Mode: Displays the querier election participate mode on the VLAN.
When this mode is disabled, up on seeing a query of the same version in the vlan, the snooping
querier move to non querier state. Only when this mode is enabled, the snooping querier will