User Manual

- 198 -
Default Setting
None
Command Mode
Interface Config
7.3.14 Service Port Commands
7.3.14.1 show serviceport
This command displays service port configuration information.
Syntax
show serviceport
Default Setting
None
Command Mode
Privileged Exec
Display Message
Interface Status: Indicates whether the interface is up or down.
IP Address: The IP address of the interface. The factory default value is 0.0.0.0.
Subnet Mask: The IP subnet mask for this interface. The factory default value is 0.0.0.0.
Default Gateway:The default gateway for this IP interface. The factory default value is 0.0.0.0.
IPv6 Administrative Mode: Whether enabled or disabled. Default value is enabled.
IPv6 Address/Length: The IPv6 address and length. Default is Link Local format.
IPv6 Default Router: The default gateway address on the service port. The factory default value is
an unspecified address.
ServPort Configured Protocol Current: Indicates what network protocol was used on thelast, or
current power-up cycle, if any.
Burned In MAC Address: The burned in MAC address used for in-band connectivity.
7.3.14.2 show serviceport ndp
This command displays IPv6 Neighbor entries.
Syntax
show serviceport ndp