User Manual

- 366 -
7.21.2.7 match cos
This command adds to the specified class definition a match condition for the Class of Service value (the
only tag in a single tagged packet or the first or outer 802.1Q tag of a double VLAN tagged packet). The
value may be from 0 to 7.
i
This command is not available on the Broadcom 5630x platform.
Syntax
match cos <0-7>
Default Setting
None
Command Mode
Class-Map Config
7.21.2.8 match destination-address mac
This command adds to the specified class definition a match condition based on the destination MAC
address of a packet. The <address> parameter is any layer 2 MAC address formatted as six, two-digit
hexadecimal numbers separated by colons (e.g., 00:11:22:dd:ee:ff). The <mac-mask> parameter is a
layer 2 MAC address bit mask, which need not be contiguous, and is formatted as six, two-digit
hexadecimal numbers separated by colons (e.g., ff:07:23:ff:fe:dc).
i
This command is not available on the Broadcom 5630x platform.
Syntax
match destination-address mac <address> <mac-mask>
<address> - Specifies any layer 2 MAC address.
<mac-mask> - Specifies a layer 2 MAC address bit mask.
Default Setting
None
Command Mode
Class-Map Config