Security System User's Guide

FortiGate-5001A Security System Guide
20 01-30000-83456-20081023
Resetting a FortiGate-5001A board Hardware installation
Resetting a FortiGate-5001A board
You must eject the FortiGate-5001A board from the chassis slot to cycle the
power and reset the board. See “Removing a FortiGate-5001A board” on page 18
for information about how to eject a FortiGate-5001A board from a chassis.
Installing and removing AMC modules
This section describes installing a FortiGate AMC Double width Module (ADM) in
the FortiGate-5001A-DW front panel AMC double-width opening or a FortiGate
AMC Single width Module (ASM) in the FortiGate-5001A-SW front panel AMC
single-width opening.
This section describes:
• Inserting AMC slot filler panels
• Inserting AMC modules
• Removing AMC modules
!
Caution: Do not operate the FortiGate-5001A board with an open AMC opening. For
optimum cooling performance and safety, the AMC opening must contain a slot filler panel
or a FortiGate AMC module.
!
Caution: Because the FortiGate-5001A board does not support hot swapping AMC
modules, you must eject the FortiGate-5001A board from its chassis slot and completely
open the handles before inserting or removing AMC modules or slot filler panels.
Table 6: FortiGate AMC module LEDs
LED State Description
HS Off Normal operation.
Blue Ejection latch open.
Flashing The module is starting up or shutting down.
OOS Off LED currently not in use.
PWR Amber The module is properly inserted in the FortiGate unit.
Off The module is not receiving power from the FortiGate unit.
OT Off LED currently not in use.
LINK Green The correct cable is in use and the connected equipment has
power.
Off No link established.
ACT Flashing
Green or
Amber
Network activity at this interface.
Off No network activity at this interface.
ACT/RDY Amber The module is properly inserted in the FortiGate unit.
Off The module is not receiving power from the FortiGate unit.
PORT Off LED currently not in use.