Instructions / Assembly

1 2
Installation Instructions
2” and 3” Flat Pyramid Caps
26 13
Installed on Fe or Al Posts
3 4
1. The following components are included with the
FortressAccents 2” and 3” Flat Pyramid Caps: Post Cap,
Post Cap Base, Light Slot Cover, 4 - Machine Screws,
2 - Hex Head Set Screws, and a 2.5mm Hex Wrench.
Remove the 4 Machine Screws, located at each corner.
Remove the Post Cap and Light Slot Cover. Do not
discard the screws. They will be used again.
2. Place the Post Cap Base on the post. Using the
supplied 2.5mm Allen Wrench tighten the two set
screws. Adjust the screws to center and level the Post
Cap on the post.
If installing the optional FortressAccents LED Cap
Light Kit, reference those instructions before
installing FortressAccents Flat Pyramid Cap.
3. Place Light Slot Cover back onto Post Cap Base.
Position Post Cap onto the Post Cap Base.
4. Secure Post Cap with the 4 Machine Screws that were
removed in step 1.
Please visit www.fortressaccents.com for information on how to order additional accessories.
For technical assistance, please email: [e-mail]
Hours of Operation Monday through Friday 8:00 AM to 5:00 PM, CST
Phone: [phone] Fax: [phone]
www.fortressaccents.com
It is the responsibility of the installer to meet all code and safety requirements. The installer should determine
and implement the appropriate installation techniques for each situation. The Fortress Company nor its
distributors shall not be held liable for improper or unsafe installations.
Required Materials: Phillips Head Screw Driver, Eye Protection