Installation Guide

Installation Instructions for Fortress
Pure View Railing Panels with
Universal (UB) Brackets and Iron Posts
Required Materials
3/16" Drill, Drill Bits, T-25 Driver Bit, Drill Bit Extender, T
ape Measure, Wrenches, Speed Square, Center Punch, 3-3/4”
Support and Hammer.
1/2” minimum
Added Blocking
*Reference Fortress iron post mounting instructions
Mount Iron Posts*
• Wood Blocking tied to deck frame must be installed and constructed with treated dimensional lumber with a minimum
thickness of 1/1/2”.
• Position the edge of post base plate a minimum of ½”from the inside edge of rim joist.
• Mount posts at appropriate points based on panel length.
• Attach Iron posts with 3/8 X 3-1/2” Hex Head Galvanized Bolts.
Note
When cutting Fortress railing, it is very important to complete the following at cut points. Not following the below steps will
result in rust at the cut areas:
• Remove all metal shavings from the cut area
• File any sharp edges left by cutting. Thoroughly wipe and remove any filings, grime or dirt from the railing.
• Apply two coats of Fortress zinc based touch-up paint to the cut area. If touch up is at rail ends, allow paint to dry before
connecting bracket to post.
• Be sure to remove any metal shavings from the surface of deck, patio or balcony to prevent rust on the surface.
It is the responsibility of the installer to meet all code and safety requirements, and to obtain all required building permits.
The deck and railing installer should determine and implement appropriate installation techniques for each installation
situation . The Fortress Company or its distributors shall not be held liable for improper or unsafe installations.
Fortress Iron Posts must always be secured to the deck framing. Fortress Iron Posts should never be attached to only the
deck boards.
For technical assistance, please email: [e-mail]
Hours of Operation Monday through Friday 8:00 AM to 5:00 PM, CST
Phone: [phone] Fax: [phone]
www.fortressrailing.com