User Guide

Bridge GUI Guide: Security Configuration
130
 Action - determines how packets selected by the local and
remote subnet parameters specified above will be handled:
 Drop - drop packets without further processing
(default selection)
 Bypass - receive and send only packets unprotected
by IPsec
 Apply - receive and send only packets protected
by IPsec
 Peer Address - if the Action to be applied by the SPD entry
is
Apply, you must identify the IP address of the remote
device to and from which IPsec-protected traffic will be
sent. If the
Action is Drop or Bypass, no IPsec peer is
expected for the SPD and you cannot enter an IP address
in this field.
Figure 4.5. IPsec Security Policy Database entry frame, all platforms
To add an IPsec SPD entry to a Bridge interface:
1 Log on to the Bridge GUI through an Administrator-level
account and select
Configure -> IPsec from the menu on the
left.
2 In the IPsec Settings screen’s Security Policies frame, click
ADD SPD and, on the resulting screen, enter valid values for
the settings described above.
3 Click APPLY in the upper right of the screen (or CANCEL the
addition).
The SPD entries you add are listed in the
Security Policies
frame.
To delete IPsec SPD entries:
1 Log on to the Bridge GUI through an Administrator-level
account and select
Configure -> IPsec from the menu on the
left.
2 In the IPsec Settings screen’s Security Policies frame:
 If you want to delete a single SPD entry or selected
entries, click to place a checkmark in the box(es)
beside the entry(-ies) you want to eliminate.
or
 If you want to delete all SPD entries, click ALL at the top
of the
Security Policies list to check all entries.
Click the
Security Policies frame’s DELETE SPD button.
Deleted SPD entries are removed from the
Security Policies list.