User's Manual

ES210 Hardware Guide: Installation
11
2.3.2 Mast Mounting
The ES210 Universal Mounting Kit accommodates masts from
1" to 3.5" in diameter.
If you will be mounting the ES210 on a mast, first attach the
mast clamps to the mounting bracket.
Figure 2.4. Attaching Mast Clamps to the Mounting Bracket
1 Identify the two mast clamps included in the mounting kit
(pictured above).
2 Guide one end of a mast clamp through two parallel clamp
slots in the bracket so that the open loop in the clamp and
its captive screw fastener are on the same side of the
mounting bracket as the bracket’s mast notches (as
shown).
3 Repeat Step 2 for the second mast clamp.
4 Attach the ES210 to the mounting bracket:
 With two (of the four included) mounting screws
partially screwed into the top corners of the chassis,
hang the ES210 by the shafts of these screws on the
upper ES210 mounting slots in the bracket.
 Install the remaining two mounting screws through the
lower mounting slots in the bracket and into the bottom
corners of the ES210 chassis.
 Tighten all four mounting screws with a ¼" hex driver or
flat screwdriver.
5 Mount the ES210 bracket assembly by fitting a mast
through the mast clamps and, using a flathead screwdriver,
tightening the clamps’ captive screw fasteners until the
mast notches in the bracket are clamped tight against the
mast.