User's Manual

ES2440 Hardware Guide: Installation
6
deployment. Use the resulting connector/cord assembly to
connect the ES2440 to an external 30 VDC power source.
2.1.3 Port and Grounding Stud Locations
The ES2440 Mesh Point’s Serial port and three Ethernet ports,
Ethernet1/WAN/POE, Ethernet2, and Ethernet3 are located on
the front panel, along with the
DC Power inlet and recessed
Reset button (see Figure 2.1).
Figure 2.1. ES2440 Front-Panel Ports, Reset Button, LEDs and Grounding Stud Location
All ES2440 front-panel ports are protected by captive covers.
Unused ports should remain covered to protect against dust
and other debris. Covered or uncovered, all ES2440 ports are
waterproof.
The recessed button used to restore the running configuration
to factory defaults (Section 3.2) is also located on the front
panel, beneath a protective screw cap.
The LEDs located above the ES2440’s ports are described in
Section 3.1
Nine antenna connectors are situated on the ES2440 back
panel, eight corresponding, by pair, to the ES2440’s four
LEDs
Ethernet 2
Ethernet 1
serial port
DC power inlet
ports
Radio 4
Radio 3
Radio 2
Radio 1
Ethernet 1/WAN/PoE input — default encrypted port
Ethernet 2
Status
Power
Ethernet 3
default clear ports
Ethernet 3
recessed button screw cap
(reset factory defaults)
grounding stud
left rear corner
QA review draft1