Installation Guide

DECKING INSTALLATION : I-SERIES
13
Note:
Minimumboardwidthaerrippingis2-1/2”[63mm].
• Itsrecommendedtoripboardsupsidedownonyourtable
sawinordertoseeexactplacementofthesawblade
relavetothefeetoftheboard.
Fig. 2
RIPCUT
FINAL
PRODUCT
SECTION VIEW
Whereverpossible,ifanI-Seriesboardhasbeenripped,
facetherippededgeinwardstowardstheotherdecking
boardsandallowthenon-rippededgetoactastheendof
the deck�
Neverfastenthroughthewebor“feet”oftheI-Seriespro-
leinordertoavoidcrackingtheI-Seriesboard.
As shown in Fig� 3�
Fig. 3
CORRECTINCORRECT
SECTION VIEW
Cung
I-Series boards should not be cut thinner than
2-1/2”[63mm].
IfnecessaryripboththerstandlastI-Seriesboardstot
yourinstallaonspace.
Useaminimumoftwofastenersperjoist,evenlyspaced
and a minimum of 1-1/4”[32mm] from any board edge�