Installation Guide

10
DECKING INSTALLATION : INFINITY I-SERIES®
• Adrillwithadjustabletorquesengsisrecommended.
• Pre-drillintemperaturesbelow40°F[5°C].
• Pre-drillingholesizeshouldbeequaltothesmallest
  diameterofthescrew.
• Referencefastenermanufacturerforpre-drillbitsize.
• pre-drillwoodsubstructure.

• TheinstallaonofI-Seriesboardsiscomparabletothatof
 othercompositeordeckingboards.
• I-Seriesproles intended for use as structural
 members.
• Thesurfaceoverhangofthedeckmustbelimitedtoa
 maximumof1-1/4”[32mm]andtakeintoconsideraon
 thethicknessofthefasciaortrim.
• Reecvesurfaces(forexample,low-Eglassormetallic
 siding)maycauseunusualUVimpactand/orheat
  build-uponadeck,whichmaycauseunexpectedresults
 intheI-Seriesmaterial.Designyourdecktoallow
  forthiswherepossible.
• Providegroundclearanceforadequatevenlaon.
  Venlaoncanhavetheaddedbenetofassisng 
 withexpansionandcontracon.AsshowninFig.1.
• usenailstofastenI-Seriesboards.
• UsehighqualityHULKfastenerssuitableforthelifespanof
thedeckandtheatmosphericcondionsofthesite.
• I-Seriesboardsrequiretwofastenerspointsperjoist.
• Fasten 1-3/16”[30mm]fromanyedgeofaboard.


Nails Fasteners Drill