Installation Guide

DECKING INSTALLATION : INFINITY I-SERIES®
11

 TheI-SeriesStarterBoardprolecanbeusedtoframeyour
deck.Itisonlygroovedononesideandhasanishedsquare
edgeontheotherside.
• Thisperimeterboardshouldbetop-xedusingcolor
 matchingcompositedeckscrews.
• The screws should be located 1-3/16”[30mm] away
  fromanyedgeoftheI-Seriesprole.
• UseHULKhiddenfastenersbetweendeckingproles.
  AsshowninFig.2,3&4.
 
overdrivethescrewintothedeckingsurface.
 I-Seriesdeckingisnotsolidandhascaviesthatcanbe
 compromisedifyourdrilltorquesengistoohigh.

GroovedBoard StarterBoard
TopFixingScrew
HULKHidden
Fastener
GroovedBoard
StarterBoard





TopFixingScrew
SquareBoard
SquareBoard
GroovedBoard
GroovedBoard

Gapsbetweendeckboards
assistwithvenlaon
Condensaon&Evaporaon
occurnaturally.Sealingoa
deck may therefore cause a
constantlywetenvironment
that may harm the
substructure beneath, which
in the long term could
harmyourdeck.
AProperlyvenlateddeck
allowsairtomove&will
assist with clearing excess
moistureintheair.

A1-1/2”[38mm]gapbeneaththedeckisrequiredforaddionalvenlaon.