Installation Guide

DECKING INSTALLATION : INFINITY I-SERIES®
13

• Minimumboardwidthaerrippingis2-1/2”[63mm].
 • It’srecommendedtoripboardsupsidedownonyourtable
 sawinordertoseeexactplacementofthesawblade
  relavetothefeetoftheboard.

RIPCUT
FINAL
PRODUCT

• Whereverpossible,ifanI-Seriesboardhasbeenripped,
facetherippededgeinwardstowardstheotherdecking
boardsandallowthenon-rippededgetoactastheendof
thedeck.
• Neverfastenthroughthewebor“feet”oftheI-Seriespro-
leinordertoavoidcrackingtheI-Seriesboard.
 AsshowninFig.3.

CORRECTINCORRECT


• I-Series boards should not be cut thinner than
  2-1/2”[63mm].
• IfnecessaryripboththerstandlastI-Seriesboardstot
 yourinstallaonspace.
• Useaminimumoftwofastenersperjoist,evenlyspaced
and a minimum of 1-3/16”[30mm]fromanyboardedge.