Installation Guide

Fe
26
TRADITIONAL INSTALLATION
55
Fig. 95 Fig. 96
Step 3: Top Bracket Installaon
 1. Posionwood2”x4”(actual1-1/2”x3-1/2”[38mmx 
 89mm]) on stairs in line withboombrackets.
 2. Placepanelontopofwood2”x4”(actual1-1/2”x3-1/2” 
 [38mmx89mm])nexttoboombrackets.Asshownin
  Fig.97.
 3. Rakethepanelunlcenteruprightisparalleltothepost 
 orlevelandposionedasclosetonalinstallaonposion
 aspossible.
 4. Clampthepaneltothepost.Besuretoclampatfour 
 touchpointstokeeppanelinposion.AsshowninFig.98.
 5. Posionbracketparallelwithtoprail&at
  centeredonpost.Make sure inside boom of bracket is
ush with boom of rail. As shown in Fig. 99.
 6. Usepenciltomark top edge of bracket locaononpost.
 7. Dis-assemblethebracketbyremovingthebarrel  
 andscrew.Referencethebracketoponsonpage52.
 8. PlaceBracketBaseonprevioustopedgemark.  
 Centerthebaseonthepostandusepenciltoaddmarks 
 fortwoscrewholelocaons.AsshowninFig.100.
Note:
• Besurebracketbasesarecenteredonpostswhenmarking
 holelocaons.