Instructions / Assembly

22
DECK & STAIR KIT INSTALLATION: APEX DECKING & Al
13
PLUS RAILING
INSTALLATION: STAIR DECK BOARDS
Step 1: Mount Stair Deck Boards
1. CuttherequiredamountofSquareEdgeDeckBoardto
  47-7/8”[1216mm]lengths.AsshowninFig.23.EachStair
 Trayrequirestwodeckboards.
2. PosionrstcutSquareEdgeDeckBoardagainsttheback
 lipoftheStairTrayandcenteracrossthewidthoftheStair
 Tray.AsshowninFig.24.
 3. WiththeStairTrayinposion,placeawoodblockontop 
 oftheSquareEdgeDeckBoardandstrikeitwithahammer
 tomarkthestairtrayscrewlocaons.Asshownin
  Fig.25&26.
 4. TurntheSquareEdgeDeckBoardoverandusea1/2”
  [13mm]drillbittodrill1/8”[3mm]deepholesateach 
 screwlocaon.ThisallowstheSquareEdgeDeckBoardto
 layatontheStairTray.AsshowninFig.27.
 5. ConrmthetoftheSquareEdgeDeckBoardontheStair
 Tray.Adjustasrequired.
SquareEdgeDeckBoards