Instructions / Assembly

27
DECK & STAIR KIT INSTALLATION: APEX DECKING & Al
13
PLUS RAILING
*DimensionAposionsboomedgeofrail3-1/2”[89mm]abovedecksurface.
*DimensionAismeasuredfromtheboomsurfaceofpostbase.
Fig. 38

Pre-drill Dimensions: Pre-drillingwitha3/16”[5mm]drillbitisrequired
34” [864mm] Panel
Step 3: Pre-Drill and Install Brackets
Tip:
   
 
 1. UseSpringPunchtomarktheholes.AsshowninFig.40.
 2. Pre-drillbracketholeswitha3/16”[5mm]drillbit.As 
 showninFig.41.
 3. AachBrackettothepostswithsuppliedT-25
  Thread-CungScrews.Usetwoscrewsperbracket.Use 
 lowspeedsengondrill.AsshowninFig.42.
 4. Oncetopandboombracketsareinstalled,remeasure 
 bracketspacingtoconrmdimensionsusedin
  Fig.38&39ofstep2.AsshowninFig.43.
 5. Removeallmetalshavingsfromdeck,postbase
  cover,outsideandinsideofpost,andpanelbeforebracket
 isscrewedtoposttopreventcorrosion.
1/2”[13mm]3-13/16”[97mm] 36-11/16”[932mm] 13/16”[21mm]
B C
A*
D
A
B
C
B
Fig. 39
A
B
D