Instructions / Assembly

34
DECK & STAIR KIT INSTALLATION: APEX DECKING & Al
13
PLUS RAILING
Fig. 57
MarkHere
MarkHere
MarkHere
MarkHere
HalfofPanelLength
CenterofPanel
Step 3: Cut & Clean Panel
 1. Cutthepanelusingasawwithaferrousmetalcungblade.
 2. Useletosmoothcutedges.
 3. Removeanymetalshavingsanddustwithabrushorrag.
  Besuremetalshavingsinsideofpanelarealsoremoved.
 4. Makesuresurfacestobepaintedareclean.
Fig. 58
Fig. 59
Fig. 60
Step 4: Apply Spray Paint To Cut Areas
 1. Usingapieceofcardboardasamask,applythe1
st
coatof 
 Fortresszincbasedtouch-uppaint.AsshowninFig.61.
 2. Allowtodrybeforeapplyingsecondcoat.
 3. Applythe2
nd
coatofFortresszincbasedtouch-uppaint.
 4. Allowtodryandinstall.
Measure & Mark Panel Where Cuts Will Be Made
 1. Toensurerailsaresymmetrical,takethemeasurement
  foundinstep1(MeasureThePanelOpeningLength),and 
 divideitinhalftodeterminethecenterpoint.
 2. Findthecenteroftherailsandmeasureouthalfofthe 
 lengtheachdirecon.AsshowninFig.57.
 3. Marktheselocaonswithapencilonthetop&boomrail.