Instructions / Assembly

42
DECK & STAIR KIT INSTALLATION: APEX DECKING & Al
13
PLUS RAILING
Fig. 79
PostToBaluster
SpaceMustBe
LessThan4”
[102mm]
Fig. 78
Clamp
Clamp
Clamp
Clamp
Fig. 77
Top View
1/2"[13mm]
Oset
 6. Placeboompostindesiredposion.Measurespacing
  frominsideedgeofposttotherstpicketinpanel.
  Spacing CANNOT exceed4”[102mm]onbothtopand
  boomposts.AsshowninFig.79.Adjustboompost
  posioningasneeded.

 1. Markboltholelocaonsanddrilla7/16”[11mm]hole 
 throughboardandstepassembly.AsshowninFig.80&81.
 2. DismountStairstepfromStairKitassembly.Asshownin 
 Fig.82.
 3. MeasureinternalopeningbetweentheStairBrackets.As 
 showninFig.83.
 4. CutU-RimJoisttomeasuredlength.
 5. InsertcutU-RimJoistinopeningbetweenStairbrackets 
 thenuseC-Clampstoholdinplace.Asshownin
  Fig.84&85.
 6. Extendpre-drilledholesthroughcutU-RimJoist.Asshown
 inFig.86.