Operation Manual

www

.foscam.co

Shenzhen

Foscam

Intelligent

Technology

Co.,

Limited

Tel:

755

2674

5668

Fax:

755

2674

5168

4.8.2 RS485 Configuration

This camera supports the standard 485 cradle head protocol (PELCO-D and PELCO-P). Please configure the

RS485 protocol corresponding information first, or else the cradle head may cannot work.

Figure 4.69

4.9 Firewall

This section explains how to control the access permission by checking the client PC’s IP addresses. It is

composed of the following columns: Block access from these IP addresses and Only allow access from

these IP addresses.

Figure 4.70

Enable firewall, If you select Only allow access from these IP addresses and fill in 8 IP addresses at most, only

those clients whose IP addresses listed in the Only allow access from these IP addresses can access the

Network Camera. If you select Block access from these IP addresses, only those clients whose IP addresses

are in the IP list cannot access the Network Camera.

Click Save to take effect.