Use and Care Manual

www
www
.foscam.
.foscam.
us
us
Foscam Digital Technologies LLC
Telephone: [phone]
router or check the locally-attached address of your computer. Your PC contains your PC’s IP
address, gateway and DNS server. Normally, there are two DNS servers. Here you can also set
the DNS server the same with gateway.
Http Port: The default Lan port is 80.You can set another port number, such as port 8005,
8100.etc.
User&Password: Default administrator user name is admin with no password.
NOTE:
If the prompt
“
Subnet doesn
’
t match, dbclick to change!
”
appears, please enable DHCP set
camera
’
s IP address and gateway once again.
3.7 Wireless Settings
Wireless Lan Settings support three modes: Infra(Do wireless lan settings manually) and WPS
(Wi-FI Protected Set-up) and Adhoc.
If your router does not support WPS function,please go to chapter 3.7.1 and make
wireless connection settings manually.
If your router supports WPS function, please go to chapter 3.7.2 and make wireless
connection settings quickly.
If there is no wireless router, please go to chapter 3.7.3 and connect the IPCAM directly to
a host in a peer_to_peer environment.
3.7.1 Infrastructure Mode
Step 01) Please choose “Device Management” and goes to the option Wireless LAN
Settings , click “Wireless LAN Settings”. Then enable “Using Wireless LAN”.
Click the Scan button and the camera will detect all WIFI devices around the area. It should also
display your router in the list. (Figure 3.19)