User Manual

www.foscam.com
Shenzhen Foscam Intelligent Technology Co., Limited
Tel: [phone] Fax: [phone]
43
Step 3: Please click on the Save button after all settings have been entered and disconnect the network
cable. Never shut down the power of the camera until the IP camera is able to connect to the wireless
network.
The LAN IP address will disappear on the window of IP Camera Tool when the camera is configuring a
wireless connection. Wait about 1 minute, the camera should obtain a wireless connection, and the LAN
IP of the camera will show again on the window of the IP Camera Tool. The IP address may have
changed after the camera receives a wireless connection; we recommend setting a static local IP
address if this IP address changes by right clicking the camera in IP Camera Tools, setting a static IP,
and pushing OK.
Congratulations! You have set up the wireless connection of the camera successfully.
NOTE :
1 . If you fail to make a wireless connection, please refer to your seller or contact us directly for
assistance.
2 . FI9821EP and FI9831EP do not support WIFI.
WPS (WI-FI Protected Set-up)
Step 1) Press and hold the WPS button for two seconds.
Figure 4.25
Step 2) Press the WPS button on your router within 60 seconds. The WPS button is usually on the
back or side of your router. On some routers, you may need to login to the web interface and click on an
on-screen button to activate the WPS feature. If you are not sure where the WPS buttons is on your
router, please refer to your router’s User Manual.
The camera will automatically create a secure wireless connection to your router. If you have plugged in
the network cable, please plug it out. The IP Camera Tool will search the camera’s LAN IP. Make sure
the PC and the camera share the same subnet.
NOTE :
The security mode of router cannot be WEP, or else the WPS settings may be failed.