User Manual

39
Step 3: Please click on the Save button after all settings have been entered and disconnect the network
cable. Never shut down the power of the camera until the IP camera is able to connect to the wireless
network.
The LAN IP address will disappear on the window of Equipment Search Tool when the camera is
configuring a wireless connection. Wait about 1 minute, the camera should obtain a wireless connection,
and the LAN IP of the camera will show again on the window of the Equipment Search Tool. The IP
address may have changed after the camera receives a wireless connection; we recommend setting a
static local IP address if this IP address changes by right clicking the camera in Equipment Search Tool,
setting a static IP, and pushing OK.
Congratulations! You have set up the wireless connection of the camera successfully.
NOTE :
If you fail to make a wireless connection, please refer to your seller or contact us directly for
assistance.
WPS (WI-FI Protected Set-up)
Before using WPS wireless connection, you need to:
 Make sure that your wireless router has the WPS function, and has been properly connected to the
Internet.
 WPS button on the wireless router is typically located on the front panel or rear panel.TP-LINK
router's WPS button is called QSS (Quick Security Setup).
 Make sure that the ethernet cable and the camera is disconnected.
1 Click the SSID of your router and
the relevant information will be filled
in the fields automatically.
2 Enter the password
of your router.
3 Click Test to check
if the password is
correct or not.