User Manual
Table Of Contents
- Security Warning
- 1 Overview
- 2 Access the IP Camera
- 3 Surveillance Software GUI
- 4 Advanced Camera Settings
- 5 Playback
- 6 Appendix
- 6.1 Frequently Asked Questions
- 6.1.1 Install the add-on of Firefox browser, Googl
- 6.1.2 Uninstall the add-on of Firefox browser, Goo
- 6.1.3 I have forgotten the administrator password
- 6.1.4 Camera can not record
- 6.1.5 Subnet doesn’t match
- 6.1.6 No Pictures Problems
- 6.1.7 Can’t access IP camera in internet
- 6.1.8 UPnP always failed
- 6.1.9 Camera can not connect wireless
- 6.1.10 Can’t see other cameras listed in multi-dev
- 6.2 Default Parameters
- 6.3 Specifications
- 6.4 CE & FCC
- 6.5 Warranty
- 6.6 Statement
- 6.1 Frequently Asked Questions
- 7 Obtaining Technical Support
54
Capture interval: The interval time between two pictures.
D Recording
If you select this checkbox, when the motion has been detected, the camera will record automatically
and store the record files to the SD Card. Make sure the camera has inserted SD card and you have
set the SD card as the Alarm record files storage path, please go to Record—> Storage location page
to verify this settings.
The default alarm record time is 30s and pre-alarm record time is 5s, please go to Record—> Alarm
Record page and change the alarm time settings.
E Push message to the phone
If you select this checkbox, when the motion has been detected, the camera will push the message to
the phone which has been connected the camera.
F IO Output(Only 9815P)
If IO alarm is triggered and IO alarm output device will always alarm (sound alarm is issued a warning
sound, alarm lights in flash etc.). Click "Clear IO alarm output" , the alarm output device will stop
alarming. If IO alarm is triggered again after alarm interval, IO alarm output device will be restart.
Step 5: Set detect area
Click set detect area and it pop up a window, then you can draw the detection area. Click OK button after
settings. When something moving in the detection area, the camera will alarm.
Step 6: Alarm Schedule
① Alarm anytime when motion is detected
Click the black button up the MON, you will see all time range turn red. When something moving in the
detection area at anytime, the camera will alarm.
② Specify an alarm schedule
Click the week day words, the corresponding column will be selected. For example, click TUE, the all
column of TUE turns to red, that means during Tuesday whole day, when something moving in the
detection area, the camera will alarm.
Click this button and select all time range