Operation Manual

Wireless N300 High power Router
.
39
 Enable UPnP: Check/uncheck to enable/disable the UPnP feature.
 OK: Click to complete your settings.
4.5 Static Routing
When there are several routers in the network, you may want to set up static routing. Static routing determines the path of the data in your
network. You can use this feature to allow users on different IP domains to access the Internet via this device. It is not recommended to use this
setting unless you are familiar with static routing. In most cases, dynamic routing is recommended, because this feature allows the router to
detect the physical changes of the network layout automatically. If you want to use static routing, make sure the router’s DHCP function is
disabled.
 Destination Network IP Address: Specify a single IP address, say, 172.17.0.100, or an IP net segment, .say, 192.168.88.0.
 Subnet Mask: Specify a Subnet Mask that corresponds to the specified destination IP.
 Gateway: Specify the IP address for next hop.
 OK: Click to activate your settings.
Note:
 Gateway must be on the same IP net segment as device's LAN/WAN IP address.
 Subnet Mask must be entered 255.255.255.255 if destination IP address is a host.
 Subnet Mask must be entered accordingly if destination IP address represents an IP network segment. It must correspond to the specified IP
address. For example, for IP address of 10.0.0.0, you may enter a subnet mask of 255.0.0.0.