Operation Manual

Wireless N300 High power Router
.
42
8) OK: Click to save your settings.
5.3 Client Filter Settings
This section allows you to set the times specific clients can or cannot access the Internet via the devices’ assigned IP addresses and service port.
Forbid Only: Only PCs listed as Forbidden will be forbidden from accessing specified services; others are not restricted;
Permit Only: Only PCs listed as permitted will be permitted to access specified services; others will be forbidden.
 Filter Mode: Select Permit Only.
 Access Policy: Select an access policy number, say, 1, from the drop-down list.
 Policy Name: Briefly describe the current rule, say, 80.
 Start IP/End IP: Enter the same IP address, say, 110, or 2 different IP addresses, say, 110 and 120 in both boxes to specify a single PC or a
range of PCs for the current rule to apply to.
 Port: Specify TCP/UDP protocol port number (s), say, 80.
 Type: Select Both.
 Time: Specify a time period for a current rule to take effect. If the field is set to 0:00-0:00, the rule will be applied 24hrs/day.
 Day(s): Specify a day or several days for a current rule to take effect.
 Enable: Check/uncheck to enable/disable the feature.
 OK: Click to activate your settings.
For example:
If you want to prohibit PCs within the IP address range of 192.168.0.100--192.168.0.120 from accessing the Internet, do as follows: