Instructions

Table Of Contents

address is now fixed at a static IP address of http://192.168.1.105:2000. This IP address will not change even if

the camera is powered off and back on, the camera will remain on this LAN IP address. This is very important

that a static LAN IP address is set, or you may have problems later with remote access and seeing the camera

remotely if the camera loses power and reconnects on a different LAN IP address. Make sure you set a static

LAN IP address!

Figure 4.1

NOTE: If the camera cannot be accessed, please make sure the port forwarding is succeed.

HTTPS Port: The default port is 443. You can use the url to access the camera: https:// IP + HTTPS port.

ONVIF Port: By default, the ONVIF port is set to 888. Also, they can be assigned with another port number

between 1 and 65535 (except 0 and 65534). But make sure they can not be conflict with other existing ports.

RTSP Port: The default port is 554,only some IP Cameras have RTSP port.

4.4.5 Mail Settings

If you want the camera to send emails when motion has been detected, here Mail will need to be configured.

1----- SMTP Server / Port / Transport Layer Security Enter SMTP server for sender. SMTP port is usually

set as 25. Some SMTP servers have their own port, such as 587 or 465, and Transport Layer Security usually

is None. If you use Gmail, Transport Layer Security must be set to TLS or STARTTLS and SMTP Port must be

set to 465 or 25 or 587, which port you choose should be decided by which Transport Layer Security you

select.