User's Manual

No.22040078
User Manual Of DC Fan Lamp
Instruction of transmitter and receiver:
1. If the remote control can't control the fan, please reset the matching mode between transmitter and receiver.
Switch on electricity for the fan, make transmitter point to receiver, and press the ON/OFF Fan button on the
remote control until hearing "bee", the match is done successfully.
Note: the match has to be done within 10 seconds after the power electricity has been given to FAN, otherwise the
fan will skip the matching mode.
2. Please check the following cases if the match fails:?
- check battery polarity and connection in transmitter;
- if there is any other similar remote control nearby, because the same work frequency of remote controls will
interfere each other.
3. Please take battery out from transmitter and remote control, if the fan won't be used for a long period.
4. Don't squeeze signal wires, it would damage them and cause short-circuit.
Remote Control
ON/OFF the Light
ON/OFF the Fan
Speed of the Fan
Reverse switch
Natural wind
Temp erature control
Anti-theft Light
Delay closing Fan and Light
Timing control
Note:The remote works with battery 1.5V AAA x 2pcs
(not included)
1
2
3
4
5
6
7
8
9