User's Manual

17
If the display shows an error code,please refer to this sheet for a potential solution.
Error Code Possible Cause Soluton
appears on the
Power display
See E0,E1,E2,E3,E7,E8,E9,EE
“ ”E0 appears in the
Timer display
IGBT overheating.
appears in the
Timer display
No cookware found or improper
placement of cookware on the
cooking zone.
Make sure the cookware is centered on the
cooking zone,and that it’ s also inducton
compatble.See Compatble Cookware.
appears in the
Timer display
This may be caused by reduced voltage being
appears in the
Timer display
appears in the
Timer display
NTC1 break of
appears in the
Timer display
NTC1 short circuit
appears in the
Timer display
NTC2 break of
appears in the
Timer display
NTC2 short circuit
“ ”E1
“ ”E2
“ ”E3
“ ”E7
“ ”E8
“ ”E9
“ ”EE
“ ”E
Turn of unit untl to allow IGBT to
cool.Restart unit.
supplied to the house circuit If the connectons .
are correct and supplied voltage returns to
normal the code will disappear.,
VII.Troubleshooting Error Codes
This may be caused by increased
voltage being supplied to the house
circuit.If the connectons are correct and
the supplied voltage returns to
normal,the code will disappear .
Turn OFF the cooktop;then shut of the
power at the fuse or circuit breaker for
about 30 seconds.Turn the power back
on to the cooktop then press the
POWER buton to turn on the unit.If the
error message is stll being
displayed,call for service.
If the voltage of the power supply to the
cooktop is too high,it cannot operator
properly and wil show this error code.
If the voltage of the power supply to the
cooktop is too low,it cannot operate
properly and will show this error code.
Electronics fault error
message of specifc cooking
zone.
Supplied voltage to cooktop
is too high.
Supplied voltage to cooktop
is too low.