User Guide

DAC-Q5
• Mac/PC plug-n-play, no special software is needed, RCA and headphones
outputs.
• USB and optical coaxial S/PDIF inputs, can choose the input mode. With the
volume control knob that can adjust the headphones as well as the RCA output.
• Hi-Fi headphone amp chips TPA6120 OPA2134 with UPC1237 headphones
protect circuit for any 16-3200Ohm headphones.
• Stream bit-perfect 24bit/192Hkz HD with low jitter, built-in Cirrus CM6642 +
CS8416 + CS4398 DAC chips, desktop or portable DAC, stereo headphone amp,
and preamp.
• Support the phone player with OTG audio input function, if need, the OTG
pallets which have three kinds of corresponding ports(type-c/android/apple)
should be purchased.
DAC-Q5 Pro
• CSR Bluetooth 5.0 QCC3008 chip support High fidelity aptX and aptX low latency,
high gain antenna for long range streaming up to 115 ft(35m);
• Easy setup, Plug-n-play, no software is needed, connects in seconds, streams
audio from any Bluetooth-enabled media player;
• Hi-Fi headphone amp chips TPA6120 OPA2134 with UPC1237 headphones
protect circuit, newly upgraded power circuit to support 32-600 ohms
headphones；
• Bluetooth, USB, Aux, Optical and Coaxial S/PDIF inputs, can choose the input
mode. With the volume control knob that can adjust the headphones as well as
the RCA output;
• Support the phone player with OTG audio input function, Hi-Fi DAC Bluetooth
receiver and headphone amp can be connected with powered speakers or
amplifier.
DC 12VLRCOAXIALOPTICALPC-USB
AUDIO IN AUDIO OUT
②① ⑤④③
① ………………………… Power Indicator Light
② ………………………… Coaxial Indicator Light
③ ………………………… Optical Indicator Light
④ ………………………… USB Indicator Light
⑤ ………………………… Power Switch
⑥ ………………………… Input Select
⑦ ………………………… 6.35mm Headphone Output
⑧ ………………………… Volume Control
① ………………………… PC-USB Digital Input
② ………………………… Optical Digital Input
③ ………………………… Coaxial Digital Input
④ ………………………… RCA Analog Output
⑤ ………………………… DC 12V Input
* For similar products information, please refer to the product page.
Any questions, please contact us at [e-mail]
Panel Introduction
Your DAC components are not water-resistant, so it’s important that they should
be kept free of moisture. You should clean only with a dry cloth or tissue and no
liquid cleaners or solvents should be used.
Cleaning
4 5
POWER
- VOL +
SELECTON/OFF
USBOPTCOA
PHONE
① ② ③ ④
⑤ ⑥ ⑦ ⑧
Fosi Audio
DAC-Q5