Operation Manual

- 1 -
ANALOG
ENGLISH
Retrograde with Date Sweep VD86A / VD85J
Time and Date Setting
1. Pull crown out to position 3 and rotate clockwise to set day of week. Hand in upper left
indicates weekday and will automatically reset to “M” at the end of the week.
2. Keeping crown in position 3, rotate hands to set the time (make sure am/pm is set correctly).
3. Push crown back to position 1.
4. Pull crown out to position 2 and rotate counter-clockwise to set date.
5. Push crown back to position 1.
123
1 2 3
VD86A
VD85J
Date Models
Date Setting
1. Pull the crown out to position 2.
2. Turn the crown either clockwise or counter-clockwise and set the date for the previous day.
The direction that moves the date varies on different watch models.
Time Setting
1. Pull crown out to position 3.
2. Turn counter-clockwise to advance the time and continue until the day changes to the
present day.
3. Set to the correct time.
4. Push crown back to position 1.
1 2 3
DATE
revised 03 / 12
For older movements, please contact Customer Care in your country.
Contact information is located on the Customer Care page of the website.
AUTOMATIC
Automatic Winding Movement
A timepiece fitted with an automatic winding movement obtains the power to wind itself by the movement of your wrist, there is no battery.
Therefore, not wearing the timepiece for several consecutive days could exhaust the power reserve. If your watch stops, it is recommended that
you manually wind the movement by rotating the crown clockwise to achieve the necessary power reserve.
It is important your timepiece is adjusted to match the size of your wrist. A loose fit may result in a loss in capacity of the timepiece to wind
itself. When fully wound, your timepiece has a power reserve of approximately 38 hours.
Automatic TY2723 / TY2542
1. To start time-keeping, rotate the crown clockwise 15-20 times in
position 1.
2. Pull crown out to position 2 and rotate clockwise to set time. Push
crown back to position 1.
1 2
SECONDS
TY2723
1 2
POWER
RESERVE
SECONDS
TY2542